Purpose of the Above-Ground Belt Rotator Systems is to rotate and position the planar sections.
Purpose of the Above-Ground Belt Rotator Systems is to rotate and position the planar sections. While doing this, there will be no damage on surfaces of the rotated part. A desired welding corner can be formed by means of a proper positioning to the rotating part on an infinite belt. It is possible to adjust height of the part located on the machine. This situation provides a great convenience for the operator during the welding process.
The product consists of body, belt drive mechanisms, distribution board and remote operator control unit, and it has the best structural protection. As to the belt breakage, precaution has been taken with a carrier elevator. Even though the belt comes off, the part mounts up the elevator. It does not damage the operator or any part of the machine.
The operators can smoothly, sensitively and easily rotate the parts on the belt in a clockwise or counterclockwise direction. At the same time, they can move up and down to obtain the required height. The belt rotator sets consist of 2 driven units. Number of the units may be increased depending on the application and weight status.
Both units forming the set of belt rotators are driven and these two units can be operated either synchronized or independent from each other. Thus, allows the angular height of the workpiece to be adjusted.
Our products are design and produced by accordance with:
Occupational Health and Safety Regulations.
5-meter wired remote control
Adjustment of the belt arms at desired angle (hydraulic)
Elevator group carrying the part except for the belt
Easy-to-use hydraulic unit
Hydromotor drive system